Machine Operator

• Handling fiberglass material

• Maintain material on production machine

• Reading Setup sheets to determine the required materials, resin, machine speeds and quality requirements

• Reading Production orders and understanding their requirements

• Quality inspections during the product run

• Reading measuring devices such as a tape measure and calipers

• Shutdown completed products and Setup for new product runs

• Clean production tooling and equipment with acetone

• Install and adjust clamping pads on the Pultrusion machine(s) pullers to assure proper pressure to avoid slipping or cracking

• Operate the control panel on the Pultrusion machine(s)

• Other duties as assigned by your supervisor or management.

• Demonstrate proper shut down procedures when order is complete.

• All staff will be cross trained in another area on our plant floor

• Other duties as assigned by supervision.

• Previous experience operating mechanical equipment

• Ability to use hand tools

• Experience in using and reading a tape measure and calipers

• Ability to read and understand setup sheets, production orders, and resin formulations

• Frequent lifting of 2- 50 lbs.

• Standing for long periods of time

• Must be able to wear personal protective equipment.

• Must be able to comply with the rules and policies as stated in the Employee Handbook

• Take part in Hazards Material training and understand all safety procedures that go along with handling this product.

• Able to work overtime as needed.

Compensation details: 16-18 Hourly Wage

PIbfc5be7e3bec-~~~2